
Boise, ID
Slab Sawing in Boise
Flat sawing runs about $4.80–$6 a foot at 4 inches and $9.60–$12 at 8; a 100-foot job in Boise averages about $1,410.
- Wet cuts for trenches and slab removal
- Garage, basement and warehouse floors
- Driveways, sidewalks and parking lots
Slab sawing prices in Boise
Typical ranges from cost guides and a Boise estimate, not quotes. Most cutters charge a $150–$400 trip minimum, and a permit can add about $65–$130.
What to have ready
- The address, and whether the slab is indoors or outside
- How thick the slab is, or where an edge shows its depth
- How many feet of cut, or the trench length and width
- Whether there is rebar, mesh or radiant heat tubing in the slab
- How close the truck can park and where water can drain
Locates, right-of-way and slurry in Boise
A trench cut through a slab ends in digging, and Idaho counts moving any earth or rock in the ground as excavation. Request a locate through Digline 2 to 10 business days ahead, white-line the trench, and keep the work inside the 3 weeks the marks stay valid.
Cuts in a curb, sidewalk or street are inside the Ada County Highway District's right-of-way, which takes an ACHD right-of-way use permit and a licensed, bonded contractor. A driveway change on your own lot needs Planning and Zoning approval.
Wet sawing makes gray slurry. Boise makes it illegal to dump substances into a storm drain, so outdoor cuts near a gutter need the inlet blocked and the slurry picked up.
Slab sawing questions
Why is a short cut priced like a long one?
Trip minimums of $150–$400 cover the setup, so a 10-foot cut can cost the same as a 30-foot one.
How long does a typical job take?
Boise estimates plan about 8 hours of crew time for 100 feet of cutting.